PATENT PENDING AXIAL CUTTER TECHNOLOGY
- Easily slices through solids and trash found in domestic wastewater without roping or clogging.
- 20 foot cord standard
- Piggy back cord for quick installation
- Lifting bail/handle
- Automatic switch for quick installation and no external capacitor required
- VR1 delivers more flow than competition*
- VR2 delivers up to 371% more flow than competition*
*Based on internal testing and published competitor data. VR1 at 20’ of lift. VR2 at 100’ of lift.
Capacities To: VR1: 49 gpm (185.5 lpm); VR2: 33 gpm (125 lpm)
Heads To: VR1: 61 ft (18.6 m); VR2: 138 ft. (42.1 m)
Liquids Handling: domestic raw sewage
Intermittent Liquid Temp.: up to 140˚F (up to 60˚C)
Winding Insulation Temp. (Class F): 311˚F (155˚C)
Motor Electrical Data: 3450 rpm, 60 Hz, 1 ph, 115V (VR1), 230V (VR1 and VR2)
Std. Third Party Approvals: CSA
Acceptable pH Range: 6 - 9
Specific Gravity: .9 - 1.1
Viscosity: 28 - 35 SSU
Discharge (Flange Dia.): VR1: 2 in. (50.8 mm); VR2: 1-1/4 in. (31.75 mm)
Min. Sump Diameter: VRI: 24 in. (61.0 cm); VR2 Simplex 24 in. (61.0cm); VR2 Duplex: 36 in. (91.4 cm)
Motor Housing, Seal Housing, Cord Cap and Volute Case: Cast Iron, Class 30, ASTM A48
Semi-Open Impeller: VR1 = thermoplastic; VR2 = stainless steel
Power Cord: SJOOW
Mechanical Seals: Standard: Carbon and Ceramic
Pump, Motor Shaft: 416 SST
Fasteners: 300 Series SST
Cutting Mechanism: 440 SST 58-60 Rockwell
The Myers high head 7 1/2 HP submersible centrifugal grinder pumps are designed for municipal, commercial or industrial applications. These pumps are especially suited for use in pressure sewer applications or in systems with long discharge runs or high static heads. The pumps feature a heavy-duty cutter mechanism and recessed impeller designed to efficiently grind typical sewage solids into a fine slurry.
5HP Centrifugal Grinder Vortex Impeller
The Myers WG50/WG50X are rugged 5 horsepower submersible centrifugal grinder pumps designed for residential, light commercial, industrial or municipal applications. They are especially designed for grinder pump applications requiring higher flows at low to moderate heads. The WG50 features a heavy-duty cutter mechanism and recessed impeller design to efficiently grind typical sewage into a fine slurry.